This programming menu allows you to select which keypad addresses the user can access.
Program the Panel at the Keypad
-
Press 6653 (PROG), then CMD at the keypad to enter the PROGRAMMER menu.
-
Press CMD until you see MENU DISPLAY, then press any select key or area.
-
Configure the following options as needed:
|
Keypad Display |
Description |
|---|---|
|
Enter the device number (keypad address). An asterisk appears next to each selected keypad address. Enter the number again to deselect it. Press CMD to display the next set of keypad addresses (9-16). |
|
Armed Status
ARMED STATUS: *1 *2 *3 *4
*9 *10 *11 *12
|
Enter the keypad addresses (1-16) that display the armed status for areas. The Armed Areas function in the User Menu also displays the custom area name entered in Area Information. When only areas 1–8 are used, the Armed Status display shows 1 2 3 4 5 6 7 8. When areas 9 or higher are used, the keypad displays ALL SYSTEM ON or SYSTEM ON. Press CMD to display additional areas. |
Time Display
TIME DISPLAY: *1 *2 *3 *4
*9 *10 *11 *12
|
Enter the keypad addresses that can display the time and day of the week. |
Arm/Disarm Display
ARM/DIS DISPLAY: *1 *2 *3 *4
*9 *10 *11 *12
|
Enter the keypad addresses where users can arm and disarm areas. |
-
When you are finished, continue programming additional menus as needed, or press CMD until STOP displays, then press any select key or area to save the panel programming.
Program the Panel in Dealer Admin
Before You Begin
-
Verify the panel is connected to network
-
Log in to Dealer Admin.
-
Go to Customers, then select the System Name.
-
Go to Programming > Menu Display.
-
Configure the following options as needed:
|
Dealer Admin Field |
Description |
|---|---|
Armed Status Keypads
|
Enter the keypad addresses (1-16) that display the armed status for areas. The Armed Areas function in the User Menu also displays the custom area name entered in Area Information. When only areas 1–8 are used, the Armed Status display shows 1 2 3 4 5 6 7 8. When areas 9 or higher are used, the keypad displays ALL SYSTEM ON or SYSTEM ON. Press CMD to display additional areas. |
Time Display Keypads
|
Enter the keypad addresses that can display the time and day of the week. |
Arm/Disarm Display Keypads
|
Enter the keypad addresses where users can arm and disarm areas. |
-
When you are finished, select one of the following options:
-
-
If you are finished with all programming — Select Send All Changes at the top of the screen. This sends all programming changes to the panel.
-
If you are finished programming Menu Display only — Select the More icon
-