XR650 Installation and Programming Guide
XR650 Installation and Programming Guide
Breadcrumbs

Stop

The STOP option allows you to exit the Programmer menu and save panel programming changes.

  1. Press 6653 (PROG), then CMD at the keypad to enter the PROGRAMMER menu.

  2. Press CMD until you see STOP. Refer to the table below:

Keypad Display

Description

STOP

SAVING
PROGRAM

At the STOP option, press any select key or area to exit the Programmer menu and save panel programming changes. The panel performs an internal reset before exiting the Programmer.

When you select STOP, the panel performs the following actions:

  • Resets all DMP 1100 series wireless transmitters to NORMAL.

  • Clears the panel Status List and saves all programming changes.

  • Does not disarm the system. Any new areas or zones added during programming are not armed until the system is disarmed and armed again.

Missing LX-Bus Modules

After the STOP routine, the keypad displays the name of any programmed LX-Bus module that is not currently connected to the panel.

Power Up

After the panel is powered up following an AC power failure, zone transitions are not recognized for 60 seconds. Normal zone processing resumes after the 60-second period.


Last updated: