Card Formats (Dealer Admin)

Keypad Display

Description

Card Format Number

Enter the card format number (1-8).

Card Format Name

Enter the card format name.

Card Format Type

Select one of the following card format types:

• DMP

• DMP Bluetooth 56-Bit

• DMP Wavelynx 40 Bit

• Standard 26 Bit

• Standard 37 Bit (with Facility Code)

• Standard 37 Bit (without Facility Code)

• Corporate 1000 (35 Bit)

• Corporate 1000 (48 Bit)

Wiegand Code Length

When using a custom credential, enter the total number of bits (1-255) to be received in Wiegand code, including parity bits. The default is 26 bits.

Determine and program the starting position location and code length into the 734 Series Access Control Module.

Site Code Length

Enter the site code start position (0-255) in the data string. The default is 1.

Site Code Position

Enter the number of characters (1-16) the site code contains. The default is 8.

User Code Position

Enter the user code start bit position (0-255). The default is 9.

User Code Length

Enter the number of user code bits (0-255). The default is 16. On a 734 module, custom numbers can only be between 16-40. On a 734N/734N POE module, custom numbers can be between 1-255.

User Code Digits

Enter a user code digit length (4-12). The number should match the user code number length used by the panel. The default is 5.

Any selection above 5 digits requires entry of the custom card definitions with custom site and user code positions for the Wiegand string. When searching the bit string for the user code, the digits are identified and read from left to right

Require Site Code

Toggle OFF to disable this option.

Toggle ON to enable a site code.

In addition to User Code verification, door access is only granted when any one site code programmed at the Site Code Entry option matches the site code received in the Wiegand string.

Site Code 1-8

734 Module — Program up to 8 eight-digit site codes. Any previously programmed site codes display. Dashes represent blank site codes. The default is blank.

734N/734N-POE Module — Program up to 8 eight-digit site codes. Any previously programmed site codes display. The default for Site Code 1 is 127. The default for site codes 2-8 are blank.

To delete an existing site code, press any select key or area. Enter a new site code or press CMD to leave the option blank and continue to the next site code. Repeat these steps to change, delete, or add up to 8 site codes.